Installing & Servicing your Hose Reel

Extend the hose to the final latch position.
2. Remove the four screws on the locking plate and remove the plate.
3. Remove the four screws from the mounting bracket at the rear of the case.
4. Remove the four main case screws on the locking plate side.
5. Lift the outer case off the reel.
CAUTION: Do not attempt to remove the hose spool from the casing as this will release the spring tension and cause possibe damage to the spring.
6. Cut the hose clamp off swivel using a suitable tool (Eg: Side Cutters etc.).
7. Remove hose from the swivel. The hose may need to be slit along the length of the swivel. Be carefull not to cut into the swivel.
8. Pull the old hose out and remove the stopper.
9.Pull the new hose through the hole in the flange of the spool (Fig. 4.)
10. Heat the end of the hose in hot water until soft.
11. Lubricate the end of the swivel with vegtable oil or detergent solution (Fig. 5).
12. Slide clamp onto hose (Fig. 5).
13. Push new hose onto the swivel and fit new clamp onto the hose (Fig. 5).
14. Wind hose fully onto the reel, making sure the hose lies flat and neatly.
15. Pull hose end through the mouthpiece of the case. Attach the hose stopper and fitting (Fig. 3).
16. Release spring tension by pulling the hose past the latch position.
17. If additional spring tension is required, wrap loose hose around the spool.
18. Replace case cover and screws.
19. Replace locking plate and screws.